



The bituminous membrane PALLADIEN STICK is an elastomeric self adhesive waterproofing membrane obtained from distilled asphalt modified with elastomeric polymers (SBS) and special additives. The membrane is reinforced by a non –woven polyester (P), or a glass fiber tissue (V). The upper surface of the membrane is protected by polyethylene film (F) or by aluminium foil (ALU).
The lower surface of the membrane PALLADIEN STICK is protected by a siliconized polyethylene film which has to be removed during the application.
PHYSICAL AND CHEMICAL CHARACTERISTICS
Bituminous compound
- very good low temperature resistance
- excellent elongation
- absolute watertightness
- good resistance to acids and alkalis
- excellent bonding capacity
Non-woven polyester
- very good tensile strength and elongation
- tear resistant
- resistant to static loading
Glass fiber tissue
- excellent dimensional stability
Aluminium foil
- excellent protection from ultraviolet rays
- increases the ageing resistance
- reduces the spread of flame in case of fire
PACKAGING
The roll dimensions are 10m long and 1m wide. The rolls are supplied on wooden pallets and are held in position by a heat shrunk plastic bag.
INSTRUCTIONS FOR USE
Surface preparation
The surface must be smooth ,clean and dry ,free from dust,oils ,grease and other debris.
The surface is then treated with bituminous primer (EXTRALAC PRIMER at a consumption of 0.2-0.25 kg/m²) or with elastomeric bituminous primer (ELASTOLAC at a consumption of 0.3-06 kg/m²) and allowed to dry at least for 24 h before the application of the membrane.
Application
Remove the siliconized polyethylene film and press the self adhesive bituminous membrane onto the surface The overlaps between two sheets must be at least 5 cm.
The application temperature must be above 5°C.At lower temperature conditions a slight heating of the membrane is recommended.